Peel And Seal On Top Of Shingle Roofing Installation

Peel seal should be installed parallel to the slope of the roof.

Peel and seal on top of shingle roofing installation.

Peel seal is the original self stick roll roofing specifically designed for low slope residential and commercial applications. Do the same with the next shingle continuing this step until you get to the far edge of the ridge. Once you ve reached the ridge bend the shingle over the ridge so that each side is equal and nail it into place with a single nail on each side. Mfm recommends using two installers when using peel seal as a whole roof covering.

Peel seal mfm building products corp. When reroofing over peel and stick underlayment installed years prior you can generally place a new underlayment right over top of the original peel and stick then proceed with installing the new roof as normal. By following this installation method you will not have. This is because peel and stick underlayments are designed to be a permanent installation so when reinstalling over top of this type.

Installing peel and stick roll roofing on a flat roof requires a minimum slope of 1 2 inch per 12 inch roof run. Typically a flat roof is a low sloping roof with a maximum 10 degrees of pitch or usually having a slope of up to 3 inches per linear foot for adequate drainage.